AP550 Flat Label Applicator- Specifications

AP550 Label Applicators Specifications

Container Platform  12” W x 12.2” D [305 x 310 mm] *
Container Height  .002” to 8” [.05 mm to 203 mm] **
Container Shape  Flat, tapered
Label Width  .75” to 4” [19 mm to 101.6 mm]
Label Height  .75” to 6” [19 mm to 152.4 mm]
Label Liner Width  .875” to 4.125” [22.2 mm to 104.8 mm]
Label Placement  Leading edge up to 8” [203 mm] from trailing container edge
Label Roll Diameter  8” [203 mm] (maximum)
Label Roll Core  2” to 3” ID [50.8 mm to 76.2 mm]
Sensor Type Optical Sensor
Electrical Rating  12 VDC, 5.0 A
Power Requirements  00-240 VAC, 50/60 Hz, 60 watts
Agency Certifications  UL, UL-C, CE, FCC Class A
Weight  24 lbs [10.9 kg]
Dimensions  12” W x 21.3” D x 10.1”–15.4” H
[305 x 541 x 256–391 mm]
Gap between Labels: Recommended: 1/8" - 1/4" ( 3.175 mm - 6.3500 mm )
Label Type: Die cut with waste removed. Black mark or gap for label sensor. Clear labels must have black mark on liner.
Liner Thickness: 2 mil - 10mil (smoothness will affect feeding - a liner that is too slippery or too thin will slip through the drive rollers)
Label + Adhesive Thickness: 5 mil - 15 mil***
Wind Direction Wound out - See Copy-Position Chart (Position 3 or 4 for most containers)
Assembled  USA
 
* Container may overhang platform to the front and/or either side.
 
** Containers shorter than .8” (20.3 mm) may require adaptive spacers.
 
***Pliability/Flexibility/Rigidity of the label is also a factor. If the label is too flexible, no matter the thickness, it can cause wrinkling or it may not pop off the liner when going around the peel edge. Polypropylene, Polyester and Vinyl labels tend to be more flexible that paper labels. If you suspect the label stock is too flexible, it is recommended that the stock and container be tested on the Applicator before making any purchase decisions of label stock or the applicator.